Description
+1 Mag Base Pad for the M&P Shield .45
We are proud to introduce the newest member of the Hyve Technologies Mag Extension family. The Shield .45 +1. Unlike our other Shield extensions, this +1 features our new snap in design, followed up with a set screw to add extra insurance that your mag will not slide off the back of the extension.
**Has not been tested with/May NOT fit Shield PERFORMANCE models**
ALL COLORS ARE PROPRIETARY AND NOT MEANT TO MATCH ANY MANUFACTURER COLORS.
DISCLAIMER: ‘Smith&Wesson’ is a federally registered trademark of Smith&Wesson, Inc. and is one of many trademarks owned by Smith&Wesson, Inc. Neither Hyve Technologies nor this site are affiliated with, or otherwise endorsed by, Smith&Wesson, Inc. The use of ‘Smith&Wesson’ on this page is merely to advertise the sale of Smith&Wesson pistols, parts, or components. For genuine Smith&Wesson products and parts visit www.smith-wesson.com
j (verified owner) –
I have the shield .45 performance model. This item fits very nicely. With the magazine fully seated, there is a papers thickness of space around the sides and front of the mag well and a mm or so at the back. Overall length of the magazine when assembled is only 1/2 an inch longer on the front of the magazine and 1/4 inch at the back. Weighs maybe a few grams more than the original extension.
***CHECK YOUR MAGAZINE FIRST***
Take it apart and look at the spring. If the spring is red or extends about 3 in past the bottom of the magazine (7 round mag) you’re good to go. If the spring is blue or extends only about an inch past the bottom of the magazine (6 round mag) it wont have enough tension on the follower to lock the slide to the rear when empty or feed rounds while firing.